Rick Bennett's Oval Tubing Press

Here Ya Go guys. One hell of a neat rig. The following is from Rick Bennett. Rick is also the editor of The Great War Planes Newsletter. He's always looking for stories and photos about WWI planes. His email address is: komodo@alltel.net

********************
Here's the tool I used to crush the tubing for my Nieuport. The steel channel is 3" x 1" x 1/4" by 12 feet long. There are 3/8" bolts welded to the sides every 12". Nuts welded to the top channel have had the trheads drilled out. Also, the threads are ground off where the tube will ( Might )  touch the bolts when crushed. Stops could be added instead of measuring to get an even diameter. Tighten evenly one or two turns at a time. You will have to go slightly past as the tube will spring back a little. The cost was about $35.00. I did five 12' pieces and used the best ones for the lower wing spars.    

Click on the thumbnails below to get the larger image.

Back to the Dawn Patrol's home page.

About The Dawn Patrol    Frequently Asked Questions    Get On The Builder's Chat List    Order Dick Starks' Book    Order Our Video Tapes    The Dawn Patrol's Trailers    2002 Air Show Schedule    Goods FOR SALE    Tom Glaeser's Chainsaw Starter    Marvin Story's Tubing Notcher    Dick Hartzler's Cowlings    Our Rib Bending JIgs    Nieuport Engine Mounts    Weight and Balance Information    Book and Video Order Form    Assorted Aviation Links    A.F.S. Paint and Covering    Various Suppliers List    Gary's Cool Tools   Smoke System   Poster Stands